This article explains how to use the BCHS by Boretti.
CONTROLS
A) Turns the LIGHTS off
B) Turns the LIGHTS on. C) Decreases speed down to minimum speed. If pressed for 2" the motor is turned off. D) Activates the motor (calling the last speed used) and increases the speed until reaching maximum. E) FILTER ALARM/TIMER RESET: when pressing the key during display of the filter alarm (motor off) it resets the hour counter. When pressing the key when the motor is running, the TIMER is activated and the hood will automatically be switched off after 5 minutes. L1) The 4 green LEDs indicate the running speed. L2) When the LED is red (motor off) it indicates the FILTER ALARM. When the LED is green (flashing) it indicates that the TIMER has been activated with the key E. FILTER ALARM: After 30h of operation, the LED L2 turns RED. It indicates that the grease filters need to be cleaned. After 120h of operation, the LED L2 turns RED and flashes; It indicates that the grease filters need to be cleaned and the charcoal filters replaced. After cleaning the grease filters (and/or replacing the charcoal filters), restart the hour counter (RESET) by pressing the key E during display of the filter alarm. OFF ON OFF/- ON/+ L1 E L2 CONTROLS P1) Lights OFF: If pressed, lights go off. P2) Lights ON: If pressed, lights go on. P3) OFF/- Motor: Speed drop until minimum speed is reached. If pressed for 2", motor switches off. If pressed for 2" with FILTER RESET on HOUR count reset. P4) ON/+ Motor: Starts motor and increases motor speed until top speed is reached P5) ON/OFF: Switches Sensor off and on(AUTOMATIC or MANUAL mode). In Automatic mode, LED L2 is on and L1 shows operating speed In Manual mode, LED L2 is off. L1) 4 LEDs 4 GREEN LEDs. Indicate set speed L2) 4 LEDS GREEN indicates AUTOMATIC mode OFF indicates MANUAL mode RED indicates Filter Reset FILTER RESET: shown with Motor Off for 30": After 30h the LED L2 becomes steady RED. After 120h LED L2 becomes flashing RED Reset by means of P3 SENSITIVITY: In manual mode, by pressing P5 and P4 together, sensitivity mode is entered. The set sensitivity is indicated by the 4 green LEDs. By means of buttons P3(-) and P4(+) the desired sensitivity is set. By pressing P5 the sensitivity can be stored, with return to manual mode. OFF ON OFF/- ON/+ ON/OFF L1 P1 P2 P3 P4 P5 L2 CONTROLS Key A: light switch. Key B: first speed motor ON/OFF switch. Key C: second speed switch. Key D: third speed switch. CONTROLS ㅇㅇㅇ Button A: light button. Button B: first speed motor ON/OFF button. Button C: second speed motor ON/OFF button. Button D: third speed motor ON/OFF button. E: motor on light. CONTROLS Key A; light switch; position 0: light off; position 1: light on. Key B: motor switch;
- position 0: motor off;
- position 1-2-3: motor first, second and thrid speed motor on. 001 01