This article covers the safety guidelines for the BCHT by Boretti.
⚠ WARNING: Failure to install the screw or fixing device in accordance with these instructions may result in electrical hazard. Only for hoods with electronic control: The 4th speed (intensive) is automatically lowered to 3nd speed after 5 minutes of operation to optimize energy consumption. If the hood is left on (lights and/or motor), after 10 hours in the absence of commands from the user, it will automatically switch to OFF condition with all services switched off.- The Buzzer emits a "beep" each time that a command is set from the keyboard or remote control (optional). In the event of interruption of power during the hood, if you restore the hood in the OFF state, then the engine must be reactivate manually. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. WARNING: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. ATTENTION: TO PREVENT DAMAGING THE SENSOR, DO NOT USE SILICONE PRODUCTS NEAR THE HOOD! For accidental reasons or due to installation faults, this device could engage and automatically shut off the motor, thereby preventing serious damage to the equipment. In such cases, after allowing the motor to cool down, the hood can be switched on again; the cause of the fault will nonetheless have to be remedied, ensuring installation has been correctly made and that all the instructions in the Information sheet have been complied with.