This article explains how to use the BKI 102 by Boretti.
Installing and operating your fridge
Before starting to use your fridge, you should pay attention to the following points: • The operating voltage for your fridge is 220-240 V at 50Hz. • The plug must be accessible after installation. Your fridge may have a smell when it is operated for the first time. This is normal and the smell will fade away when your fridge starts to cool. • Before connecting your Fridge Freezer, ensure that the information on the data plate (voltage and connected load) matches that of the mains electricity supply. If in doubt, consult a qualified electrician. • Insert the plug into a socket with an efficient ground connection. If the socket has no ground contact or the plug does not match, we recommend that you consult a qualified electrician for assistance. • The appliance must be connected with a properly installed fused socket. Power supply (AC) and voltage at the operating point must match with the details on the name plate of the appliance (name plate is located on the inside left of the appliance). • We do not accept responsibility for any damages that occur due to ungrounded usage. • Place your fridge where it will not be exposed to direct sunlight. • Your fridge should never be used outdoors or exposed to rain. • Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores, and at least 5 cm away from electrical ovens. • When your fridge is placed next to a deep freezer, there should be at least 2 cm between them to prevent humidity forming on the outer surface. • Do not place heavy items on the appliance. • Clean the appliance thoroughly, especially the interior, before use (see Cleaning and Maintenance). • The installation procedure into the kitchen unit is given in the Installation Manual. This product is intended to be used in proper kitchen units only. • Use the adjustable front legs to make sure your appliance is level and stable. You can adjust the legs by turning them in either direction. This should be done before placing food in the fridge. • Before using your fridge, wipe all parts with a solution of warm water and a teaspoon of sodium bicarbonate, then rinse with clean water and dry. Place all parts in the fridge after cleaning. Before Using your Fridge • When using your fridge for the first time, or after transportation, keep it in an upright position for at least 3 hours before plugging into the mains. This allows efficient operation and prevents damage to the compressor. • Your fridge may have a smell when it is operated for the first time. This is normal and the smell will fade away when your fridge starts to cool. PART-2. THE VARIOUS FUNCTION AND POSSIBILITIES Thermostat Setting • The thermostat automatically regulates the inside temperature of the refrigerator. By rotating the knob from position 1 to 5, colder temperatures can be obtained. • The "." position shows that the thermostat is closed and no cooling will take place. • For short-term storage of food in the refrigerator, you can set the knob between minimum and medium positions (1-3). • For long-term storage of food in the refrigerator, you can set knob to the medium position (3-4). Note that: the ambient temperature, temperature of the freshly stored food and how often the door is opened, affects the temperature in the refrigerator. If required, change the temperature setting. • When you first switch on the appliance, you should ideally try to run it without any food in for 24 hours and not open the door. If you need to use it straight away, try not to put a large quantity of food inside the appliance. • If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting in order not to damage the compressor. LARDERS (without star rating): Larders (coolers) do not have a freezer compartment but can cool down to 4 - 6°C.
⚠ Warnings about Temperature Adjustments • It is not recommended that you operate your fridge in environments colder than 10°C in terms of its efficiency. • Temperature adjustments should be made according to the frequency of door openings and the quantity of food kept inside the fridge. • Your fridge should be operated up to 24 hours according to the ambient temperature without interruption after being plugged in to be completely cooled. Do not open doors of your fridge frequently and do not place much food inside it in this period. • A 5 minute delaying function is applied to prevent damage to the compressor of your fridge, when you take the plug off and then plug it on again to operate it or when an energy breakdown occurs. Your fridge will start to operate normally after 5 minutes. • Your fridge is designed to operate in the ambient temperature intervals stated in the standards, according to the climate class stated in the information label. We do not recommend operating your fridge out of stated temperatures value limits. • This appliance is designed for use at an ambient temperature within the 16°C - 32°C range. ARRANGING FOOD IN THE APPLIANCE • The refrigerator is used for storing fresh food for few days. • Do not place food in direct contact with the rear wall of the refrigerator compartment. Leave some space around food to allow the circulation of air. • Do not place hot food or evaporating liquid in the refrigerator. • Always make sure food is wrapped or stored in closed containers before placing in the refrigerator. • To reduce humidity and avoid formation of frost, never place liquids in unsealed containers in the refrigerator. • We recommend that you loosely wrap meat and store it on the glass shelf just above the vegetable bin, where the air is cooler. • Store fruit and vegetable items loose in the crisper containers. • To prevent the cold air escaping, try not to open the door too often, and not leave the door open for a long time. PART-4. CLEANING AND MAINTENANCE • Disconnect the unit from the power supply before cleaning. • Do not clean the appliance by pouring water. • Make sure that no water enters the lamp housing and other electrical components. • The refrigerator should be cleaned periodically using a solution of bicarbonate of soda and lukewarm water. • Clean the accessories separately with soap and water Do not clean them in the dishwasher. • Do not use abrasive products, detergents or soaps. After washing, rinse with clean water and dry carefully. When you have finished cleaning, reconnect the plugto the mains supply with dry hands. PART-3. ARRANGING FOOD IN THE APPLIANCE • The refrigerator is used for storing fresh food for few days. • Do not place food in direct contact with the rear wall of the refrigerator compartment. Leave some space around food to allow the circulation of air. • Do not place hot food or evaporating liquid in the refrigerator. • Always make sure food is wrapped or stored in closed containers before placing in the refrigerator. • To reduce humidity and avoid formation of frost, never place liquids in unsealed containers in the refrigerator. • We recommend that you loosely wrap meat and store it on the glass shelf just above the vegetable bin, where the air is cooler. • Store fruit and vegetable items loose in the crisper containers. • To prevent the cold air escaping, try not to open the door too often, and not leave the door open for a long time.