BR-83 - Maintenance and cleaning

This article covers maintenance and cleaning of the BR-83 by Boretti.

• Disconnect the appliance from the power supply before cleaning. • Do not pour water over the appliance. • • The refrigerator compartment should be cleaned periodically using a solution of bicarbonate of soda and lukewarm water. • Clean the accessories separately with soap and water. Do not put them in the dishwasher. • Do not use abrasive products, detergents or soaps. After washing, rinse with clean water and dry carefully. When the cleaning operations have been completed, reconnect the plug with dry hands. Defrosting the Refrigerator • Defrosting occurs automatically in refrigerator during operation; the defrost water is collected by the evaporating tray and evaporates automatically. • The defrost water drain hole should be cleaned periodically with defrost drain plug to prevent the water from collecting on the bottom of the refrigerator instead of flowing out. • You can also pour 1½ glass of the water to drain hole to clean inside. Replacing the Light Bulb When replacing the bulb of the refrigerator;

2. Press the hook in front of the light cover such as Figure 1 and remove the light cover.

3. Change the present light bulb with a new one of not more than 15 W.

4. Replace the light cover and after waiting 5 minutes plug the unit. If your refrigerator is not working properly, it may be a minor problem, therefore check the following. The appliance does not operate, Check if; • There is a power failure, • The mains plug is not properly plugged in, or is loose • The thermostat setting is on position “0”, • The socket is defective. To check this, plug in another appliance that you know which is working into the same socket. The appliance performs poorly; Check if; • You have overloaded the appliance, • The doors are not closed perfectly, • There are not enough ventilation ducts on the kitchen unit as mentioned in the Installation Manual. If there is noise; The cooling gas which circulates in the refrigerator circuit may make a slight noise (bubbling sound) even when the compressor is not running. Do not worry, this is quite normal. If these sounds are different check if; • The appliance is installed firmly as described in the Installation Manual. • The objects on the appliance are vibrating. If there is water in the lower part of the refrigerator; Check if; The drain hole for defrost water is not clogged (use defrost drain plug to clean the drain hole). If your fridge is not cooling enough; Your fridge is designed to operate in the ambient temperature intervals stated in the standards, according to the climate class stated in the information label. We do not recommend operating your fridge out of stated temperatures value limits in terms of cooling effectiveness.

Was this article helpful?

0 out of 0 found this helpful

Didn’t find an answer to your question?