This article explains how to use the BRN-102 by Boretti.
USING THE APPLIANCE FOR THE FIRST TIME
Connect the appliance to the mains power supply. On models with electronics, an audible signal may sound, indicating that the temperature alarm has been activated: press the alarm sound off button. Attach the antibacterial filter against unpleasant odours to the fan, as indicated in the filter packaging. Note: After switching on the appliance, wait 4-5 hours for the correct storage temperature to be reached for a normally filled appliance. WHEN NOT IN USE Disconnect the appliance from the mains power supply and empty, defrost (if necessary) and clean the appliance. Leave the doors slightly ajar to allow air to circulate in the compartments. This will prevent the development of mould and unpleasant odours. IN CASE OF A POWER FAILURE Keep the doors closed to keep food cool for as long as possible. Do not refreeze partially defrosted food. In the event of a prolonged power failure, the blackout alarm may be activated (on products with electronics). REFRIGERATOR COMPARTMENT The refrigerator compartment can be used to store fresh food and drinks. The refrigerator compartment defrosts automatically. The presence of water droplets on the inner rear wall of the refrigerator compartment indicates the automatic defrost phase. The defrost water drains into a drain opening and then into a tray, where it evaporates. Depending on the model, the product may be equipped with a special "Zero degrees" compartment, which is ideal for storing fresh meat and fish.
⚠ Warning: do not clean the refrigerator accessories in a dishwasher. Note: ambient temperature, frequency of door opening and appliance location can affect the temperatures in the two compartments. Adjust the temperature according to these factors. Note: if there is a lot of moisture in the refrigerator compartment, condensation may form, especially on the glass shelves. In this case, it is advisable to cover liquids in open containers (e.g. a container of broth), wrap food with high water content (e.g. vegetables) in foil and switch on the fan (if equipped). Removing the vegetable and fruit drawer (depending on the model) Pull the drawer out as far as possible, lift it and remove it from the refrigerator compartment. To make it easier to remove the vegetable and fruit drawer, you can first empty (and if possible remove) the two lower door compartments. Fan and antibacterial filter against unpleasant odours (depending on the model) The fan ensures uniform temperature distribution in the compartments, thus preserving food better and reducing humidity. Ensure that ventilation openings are not blocked. The fan can be switched on and off manually (see Quick Guide); when switched on, it operates automatically. FREEZER COMPARTMENT Model with separate freezer compartment The **** freezer compartment can be used to store frozen food (for the period indicated on the packaging) and to freeze fresh food. The amount of fresh food that can be frozen in 24 hours is indicated on the rating plate. Arrange fresh food in the freezer compartment (see Quick Guide) and ensure sufficient space around each package for air circulation. It is advisable not to refreeze partially defrosted food. It is important to package food in such a way as to prevent the ingress of water, moisture or condensation. Making ice cubes Fill the ice tray 2/3 full with water and place it in the freezer compartment. Never use pointed or sharp objects to remove ice. Removing the drawers (depending on the model) Pull the drawers out as far as possible, lift them and remove them. For more storage capacity, the freezer compartment can be used without the drawers. Ensure the door is properly closed after placing food on the racks/shelves. Models with an internal product compartment In the **** freezer compartment, you can also freeze fresh food. The amount of fresh food that can be frozen in 24 hours is indicated on the rating plate. Freezing fresh food: • arrange the food directly on the bottom of the compartment (illustration 1 and 2) • place the food in the middle of the **** compartment, without it coming into contact with already frozen food, maintaining a distance of approximately 20 mm (illustration 1 and 2). DEFROSTING THE FREEZER COMPARTMENT (depending on the model) For frost-free models, no defrosting procedures are necessary. For other models, ice formation is normal. The amount and speed of ice formation vary depending on ambient conditions and how often the door is opened. It is recommended to lower the temperature four hours before removing food from the freezer compartment or to activate the Quick Freeze function (see Quick Guide), if available, to extend food preservation during the defrosting phase. To defrost the compartment, switch off the appliance and remove the drawers. Place the frozen food in a cool place. Leave the door open to allow the ice to melt. To prevent water from running out during defrosting, it is advisable to place an absorbent cloth at the bottom of the freezer compartment and wring it out regularly. Clean the inside of the freezer compartment and dry thoroughly. Switch the appliance back on and replace the food. "ZERO DEGREES" COMPARTMENT (depending on the model) The "Zero degrees" compartment is specifically designed to maintain a low temperature and correct humidity to preserve fresh food for extended periods (e.g. meat, fish, fruit and winter vegetables). Water-repellent technology, combined with Activo", ensures the best preservation of food when it is not fully packaged. Switching the compartment on and off To switch on the compartment, press the button shown in the illustration for longer than 1 second until the symbol lights up. When the symbol is lit, it means the compartment is on. To switch off the compartment, press the button for longer than 1 second. To completely switch off the compartment, you must remove the drawer. For the "Zero degrees" compartment to function correctly, the following conditions must be met:
- the refrigerator compartment must be switched on
- the temperature must be between +2 °C and +4 °C
- the drawer must be in the "Zero degrees" compartment for it to be switched on
- none of the following special functions must be selected: stand-by, cooling off, holiday (if present); in this case, remove the food from this compartment. Note: if the symbol for the "Zero degrees" compartment switches off or on again when switching on or if the drawer is correctly placed, contact the Technical Service Centre if the problem persists.
- when the compartment is switched on or the drawer is opened, the symbol on the control panel will switch off automatically. The symbol will light up again when the drawer is reinserted.
- note: the status of the compartment may produce a loud noise. This is normal.
- when the "Zero degrees" compartment is not in operation, the temperature in the compartment depends on the general temperature of the refrigerator compartment. In this case, it is advisable to store fresh fruit and vegetables that are not sensitive to cold (berries, apricots, carrots, spinach, lettuce, etc.) here. Important: if the compartment is switched on and there is food with high water content, condensation may form on the shelves. Activate the "Zero degrees" function in this case. Be careful when placing small items of food and containers on the top shelves of the "zero degrees" compartment. Prevent them from accidentally falling between the shelves and the rear wall of the refrigerator compartment. Removing the "Zero degrees" compartment: Follow these steps:
- to remove the compartment, we recommend that you empty (and if possible remove) the lower door compartments
- switch off the compartment
- remove the compartment by tilting it upwards
- remove the white plastic plate under the compartment Note: it is not possible to remove the top plate and side supports. To reuse the "Zero degrees" compartment, carefully replace the white plastic plate under the compartment before reinserting the drawer and switching the function back on. For greater storage capacity and lower energy consumption, it is recommended to switch off the "Zero degrees" compartment and remove it. Regularly clean the compartment and its components with a cloth using a solution of lukewarm water (ensure the white plastic plate under the drawer is not submerged) and a neutral detergent suitable for cleaning the inside of the refrigerator. Do not use abrasive detergents. Before cleaning the compartment (including the exterior), the drawer must be removed to disconnect the power supply to the compartment.