This article covers maintenance and cleaning of the BRV178 by Boretti.
MAINTENANCE
Unplug the appliance before carrying out any maintenance operation.
Warning
This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periodic cleaning Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operstion will improve the performance of the appliance and save electricity consumption. Interior light The light bulb inside the refrigerator compartment can be reached as follows: • unscrew the light cover securing screw. • unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: • remove the plug from the wall socket; • remove all food; • defrost and clean the interior and all accessories; • leave the door ajar to allow air to circulate to prevent unpleasant smells. CUSTOMER SERVICE AND SPARE PARTS If the appliance is not functioning properly, check that: • the plug is firmly in the wall socket and the mains power switch is on; • there is an electricity supply (find out by plugging in another appliance); • the thermostat knob is in the correct position. • If there are water drops on the bottom of the cabinet, check that the defrost water drain opening is not obstructed (see "Defrosting" section). If your appliance is still not working properly after making the above checks, contact the nearest service centre. To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom left-hand side. TECHNICAL INFORMATION The technical infomation are situated in the rating plate on the internal left side of the appliance. INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
ATTENTION!
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.