This article covers maintenance and cleaning of the BRV-123 by Boretti.
PART4 CLEANING AND MAINTENANCE • Disconnect the appliance from the power supply before cleaning. Do not pour water over the appliance. • The refrigerator compartment should be cleaned periodically using a solution of bicarbonate of soda and lukewarm water. Clean the accessories separately with soap and water. Do not put them in the dishwasher. • Do not use abrasive products, detergents or soaps. After washing, rinse with clean water and dry carefully. When the cleaning operations have been completed, reconnect the plug with dry hands. Defrosting the Refrigerator Compartment: • Defrosting occurs automatically in refrigerator compartment during operation; the defrost water is collected by the evaporating tray and evaporates automatically. • The evaporating tray and the defrost water drain hole should be cleaned periodically with defrost drain plug to prevent the water from collecting on the bottom of the refrigerator instead of flowing out. • You can also pour 1½ glass of the water to drain hole to clean inside. Defrosting the Freezer Compartment:
⚠ WARNING: Never use sharp metal tools, unless recommended by manufacturer, for this operation as they can damage the refrigeration circuit. After a period of time, frost will build up in certain areas in the freezer compartment. The frost, accumulated in the freezer compartment, should be removed periodically (use the plastic scraper if available). Complete defrosting will become necessary if the frost layer exceeds 3-5 mm to maintain the efficiency of the freezer. • The day before you defrost, set the thermostat dial to position "5" to freeze the foods completely. During defrosting, frozen foods should be wrapped in several layers of paper and kept in a cool place. The inevitable rise in temperature will shorten their storage life. Remember to use these foods within a relatively short period of time. • Set the thermostat knob to position "0" and switch off the appliance. • Leave the door open to accelerate defrosting. Remove the defrost water from the compartment. Clean the interior by hand with lukewarm water and a little detergent. Never use abrasive products or aggressive cleaning agents. • Dry the inside of the unit, plug on the mains, and set the thermostat knob to position "5". After 24 hours, reset the thermostat to the desired position. Replacing the Light Bulb When replacing the bulb of the refrigerator compartment;
2. Press the hooks on the sides of the light cover top and remove the light cover
3. Change the present light bulb with a new one of not more than 15 W.
4. Replace the light cover and after waiting 5 minutes plug the unit. PART5 BEFORE CALLING YOUR AFTER SALES SERVICE If your refrigerator is not working properly, it may be a minor problem, therefore check the following. The appliance does not operate, Check if; • There is a power failure, The mains plug is not properly plugged in, or is loose The thermostat setting is on position "0", The socket is defective. To check this, plug in another appliance that you know which is working into the same socket. The appliance performs poorly; Check if; You have overloaded the appliance, The doors are not closed perfectly, • There are not enough ventilation ducts on the kitchen unit as mentioned in the Installation Manual. If there is noise; The cooling gas which circulates in the refrigerator circuit may make a slight noise (bubbling sound) even when the compressor is not running. Do not worry, this is quite normal. If these sounds are different check if; • The appliance is installed firmly as described in the Installation Manual. • The objects on the appliance are vibrating. If there is water in the lower part of the refrigerator; Check if; The drain hole for defrost water is not clogged (use defrost drain plug to clean the drain hole).