This article explains how to use the BRVN-102 by Boretti.
USING THE APPLIANCE FOR THE FIRST TIME
Connect the appliance to the mains power supply. On models with electronics, an audible signal may sound, indicating that the temperature alarm has been activated: press the button to silence the alarm. Attach the antibacterial filter against unpleasant odours to the fan, as indicated in the filter packaging. Note: After switching on the appliance, wait 4-5 hours for the correct storage temperature to be reached for a normally filled appliance. IF NOT IN USE Disconnect the appliance from the mains and empty, defrost (if necessary) and clean the appliance. Leave the doors slightly ajar so that air can circulate in the compartments. This will prevent the development of mould and unpleasant odours. IN CASE OF POWER FAILURE Keep the doors closed to keep food cool for as long as possible. Do not refreeze partially defrosted food. In the event of a prolonged power failure, the blackout alarm may be activated (on products with electronics). REFRIGERATOR COMPARTMENT The refrigerator compartment can be used to store fresh food and drinks. The refrigerator compartment defrosts automatically. The presence of water droplets on the inner rear wall of the refrigerator compartment indicates the automatic defrost phase. The defrost water runs into a drain opening and then into a tray where it evaporates. Depending on the model, the product may be equipped with a special "Zero degrees" compartment, which is ideal for storing fresh meat and fish.
⚠ Warning: do not clean refrigerator accessories in a dishwasher. Note: ambient temperature, frequency of door opening and appliance location can affect the temperatures in the two compartments. Adjust the temperature according to these factors. Note: if there is a lot of moisture in the refrigerator compartment, condensation may form, especially on the glass shelves. In this case, it is advisable to cover liquids in open containers (e.g. a bouillon pan), wrap food with high water content (e.g. vegetables) in foil and switch on the fan (if equipped). Removing the vegetable and fruit drawer (depending on the model) Pull the drawer out as far as possible, lift it and remove it from the refrigerator compartment. To make it easier to remove the vegetable and fruit drawer, you can first empty (and if possible remove) the two lower door compartments. Fan and antibacterial filter against unpleasant odours (depending on the model) The fan ensures uniform temperature distribution in the compartments, thus preserving food better and reducing humidity. Ensure that ventilation openings are not blocked. The fan can be switched on and off manually (see Quick Guide); when switched on, it operates automatically. FREEZER COMPARTMENT Model with separate freezer compartment In the **** freezer compartment, frozen food can be stored (for the period indicated on the packaging) and fresh food can be frozen. The amount of fresh food that can be frozen in 24 hours is indicated on the rating plate. Arrange the fresh food in the freezer compartment (see Quick Guide) and ensure sufficient space around each package for air circulation. It is advisable not to refreeze partially defrosted food. It is important to package food in such a way that it prevents the ingress of water, moisture or condensation. Making ice cubes Fill the ice tray 2/3 full with water and place it in the freezer compartment. Never use pointed or sharp objects to remove ice. Removing the drawers (depending on the model) Pull the drawers out as far as possible, lift them and remove them. For more storage capacity, the freezer compartment can be used without the drawers. Ensure the door is closed properly after placing food on the racks/shelves. Models with an internal product compartment In the **** freezer compartment, you can also freeze fresh food. The amount of fresh food that can be frozen in 24 hours is indicated on the rating plate. Freezing fresh food: • arrange the food directly on the bottom of the compartment (illustration 1 and 2) • place the food in the middle of the **** compartment, without it coming into contact with already frozen food, maintaining a distance of approximately 20 mm (illustration 1 and 2). DEFROSTING THE FREEZER COMPARTMENT (depending on the model) For frost-free models, no defrosting procedures are necessary. For other models, ice formation is normal. The amount and speed of ice formation vary depending on ambient conditions and how often the door is opened. It is recommended to set the temperature lower four hours before removing food from the freezer compartment or to activate the Quick Freeze function (see Quick Guide), if available, to extend the preservation of food during the defrosting phase. To defrost the compartment, switch off the appliance and remove the drawers. Place the frozen food in a cool place. Leave the door open to allow the ice to melt. To prevent water from running out during defrosting, it is advisable to place an absorbent cloth at the bottom of the freezer compartment and wring it out regularly. Clean the inside of the freezer compartment and dry thoroughly. Switch the appliance back on and replace the food. "ZERO DEGREES" COMPARTMENT (depending on the model) The "Zero degrees" compartment is specifically designed to maintain a low temperature and correct humidity to keep fresh food for longer (e.g. meat, fish, fruit and winter vegetables). Water-repellent technology, combined with Activo", ensures the best preservation of food when it is not fully packaged. Switching the compartment on and off To switch on the compartment, press the button on the control panel for longer than 1 second until the symbol lights up. When the symbol is lit, it means the compartment is on. To switch off the compartment, press the button for longer than 1 second until the symbol goes out. To completely switch off the compartment, you must remove the drawer. For the "Zero degrees" compartment to function correctly, the following conditions must be met:
- the refrigerator compartment must be switched on
- the temperature must be between +2 °C and +4 °C
- the drawer must be in the "Zero degrees" compartment for it to be switched on
- none of the following special functions must be selected: stand-by, cooling off, holiday (if present); if so, remove the food from here. Note: when the "Zero degrees" compartment is switched on, check if the drawer is correctly positioned. If the control system is activated, the Technical Service Centre
- when the compartment is switched on or the drawer is opened, the symbol on the control panel automatically goes out. The symbol lights up again when the drawer is replaced.
- note the status of the compartment, a very audible noise may be heard, this is normal.
- when the "Zero degrees" compartment is not in operation, the temperature in the compartment depends on the general temperature of the refrigerator compartment. In this case, it is advisable to store fresh vegetables that are not sensitive to cold (berries, apricots, carrots, spinach, lettuce, etc.) here. Important: if the compartment is switched on and there is food with high water content, condensation may form on the shelves. Activate the "Zero degrees" function. Be careful when placing small food items and containers on the top shelves of the "Zero degrees" compartment. Prevent them from accidentally falling between the shelves and the rear wall of the refrigerator compartment. Removing the "Zero degrees" compartment: Follow these steps:
- to make it easier to remove the compartment, we recommend emptying (and if possible removing) the lower door compartments
- switch off the compartment
- remove the compartment by rotating it upwards remove the white plastic plate under the compartment Note: it is not possible to remove the top plate and side supports. To reuse the "Zero degrees" compartment, carefully replace the white plastic plate under the compartment before reinserting the drawer and switching the function back on. For higher storage capacity and lower energy consumption, it is recommended to switch off the "Zero degrees" compartment and remove it. Regularly clean the compartment and its components with a cloth using a solution of lukewarm water (ensure the white plastic plate under the drawer is not submerged) and a neutral detergent suitable for cleaning the inside of the refrigerator. Do not use abrasive detergents. Before cleaning the compartment (including the exterior), the drawer must be removed to disconnect the power supply to the compartment.