This article explains how to use the BV-83 by Boretti.
Before switching on, place the appliance on upright position and wait at least three hours without moving the appliance. This will give the refrigerant circuit time to settle and operate efficiently. Clean the appliance thoroughly, especially in the interior, before use (See Cleaning and Maintenance). Installation of the appliance and electrical connections must be carried out by a qualified technician, in accordance with the Installation Manual and local regulations. Installation procedure into the kitchen unit is given in the Installation Manual. This product is intended to be used in proper kitchen units only. The appliance must be connected with a properly installed fused socket. Power supply (AC) and voltage at the operating point must with the details on the name plate of the appliance (name plate is located on the inside left of the appliance). Insert the plug into a socket with an efficient ground connection. If the socket has no ground contact or the plug does not match, we suggest you to call an authorized electrician for assistance. Manufacturer is not responsible for failure to complete the ground connection as described in this booklet. There can be an odor when you first switch on the appliance. It will disappear after the appliance starts to cool. PART 2. HOW TO OPERATE THE FREEZER Thermostat Setting The freezer thermostat automatically regulates the inside temperature of the compartments. By rotating the knob from position 1 to 5, colder temperatures can be obtained. "0" position shows thermostat is closed and no cooling will be available. Freezer Thermostat Setting; 0: The appliance is switched off. 1-2: For short-term storage of food in the freezer compartment, you can set the knob between minimum and medium position. 3-4: For long-term storage of food in the freezer compartment, you can set knob to medium position. 5: For freezing the fresh food. The appliance will run for colder temperatures. SF: The compressor will start to run continuously with maximum performance. The freezer temperature will decrease and the appliance will switch to the lowest temperature. Place the food to be frozen quickly inside the freezer, preferably in the middle drawers. Once the food is frozen, you must set the thermostat knob to desired position. Note 1; Observe that the orange lamp will light when the compressor runs. So when SF is active, the compressor will run continuously and the lamp will light continuously. Note 2; The ambient temperature, temperature of the freshly stored food and how often the door is opened, affects the temperature in the refrigerator and freezer compartments. If required, change the temperature setting. Display Panel Compressor light: Lights orange, when the compressor runs. In SF mode, it will light continuously. Power light: Lights green automatically, when the appliance is connected to the power supply. Alarm light: Lights red, when the temperature rises to a critical point in side the freeze.