This article covers maintenance and cleaning of the BIK-70 BIKW-75 by Boretti.
Maintenance and cleaning
Do not clean the hob if the glass is hot: risk of burn. Remove light marks with a damp cloth with washing up liquid diluted in a little water. Then rinse with cold water and dry the surface thoroughly. Highly corrosive or abrasive deter- gents and cleaning equipment likely to cause scratches must be absolutely avoided. Ensure that the bottom of pans is dry and clean. En- sure that there are no grains of dust on your ceramic hob or on the bottom of the pan. Sli- ding rough saucepans will scratch the surface. Spillages of sugar, jam, jelly, etc. must be re- moved immediately. You will thus prevent the surface being damaged. Trouble shooting Problem The cooktop or cooking zone does not work The symbol (U) lights up The symbol (F) lights up The symbol (E) lights up One or all of the zones break(s) down The fan continues to operate after the cooktop is switched off The automatic cooking control does not come into operation. Possible cause The cooktop is not properly connected to the electricity mains The safety circuit breaker has tripped Check that the interlocking has not been engaged There is water or grease on the touch controls There is an object on top of the touch controls There is no pan on the cooking zone The pan is not suitable for induction The diameter of the base of the pan is too small in relation to the cooking zone You cannot use this cooking zone any longer The electronic system is defective The safety device has come into operation This happens when you forget to switch off a cooking zone. The safety device also comes into operation when one or more of the touch controls are covered up A pan is empty and its base has overheated The cooktop has overheated. In this case the cooktop will switch itself off for safety purposes. This is not a defect. The fan does this to protect the electronic equipment and it will stop automatically The cooking zone is still warm (H) The cooking level is at the maximum (9). The cooking level was operated using the (-) control Solution Connect the appliance properly Check the circuit breaker/fuse Unlock the controls Clean the controls Remove the object from the controls Place a suitable pan on the cooking zone Place a suitable pan on the cooking zone Place a larger pan on the cooking zone Contact the technical service department Switch the equipment off and then on again Allow the pan to cool down then refill it Allow the pan to cool down then refill it Allow the cooktop to cool down Allow the cooking zone to cool down. Allow the cooking zone to cool down and try again later Switch the cooking zone off and try again later