This article covers maintenance and cleaning of the BIKP-78 by Boretti.
Entretien et nettoyage
Switch-off the appliance before cleaning. Do not clean the hob if the glass is too hot be- cause they are risk of burn. • Remove light marks with a damp cloth with washing up liquid diluted in a little wa- ter. Then rinse with cold water and dry the surface thoroughly. • Highly corrosive or abrasive detergents and cleaning equipment likely to cause scratches must be absolutely avoided. Do not ever use any steam-driven or pres- sure appliance. Do not use any object that may scratch the ceramic glass. • Ensure that the pan is dry and clean. Ensure that there are no grains of dust on your ce- ramic hob or on the pan. Sliding rough sauce- pans will scratch the surface. • Spillages of sugar, jam, jelly, etc. must be re- moved immediately. You will thus prevent the surface being damaged. What to do in case of a problem The hob or the cooking zone doesn't start-up: • The hob is badly connected on the electrical network. • The protection fuse cut-off. • The looking function is activated. • The sensitive keys are covered of grease or water. • An object is put on a key. The control panel displays ( U ): • There is no pan on the cooking zone. • The pan is not compatible with induction. • The bottom diameter of the pan is too small. The control panel displays [ E]: • The electronic system is defective. • Disconnect and replug the hob. One or all cooking zone cut-off : • The safety system functioned. • You forgot to cut-off the cooking zone for a long time. • One or more sensitive keys are covered. • The pan is empty and its bottom overheated. • The hob also has an automatic reduction of Booster level and breaking Automatic overheating Continuous ventilation after cutting off the hob : • This is not a failure, the fan continuous to protect the electronic device. • The fan cooling stops automatically. The automatic cooking system doesn't start-up : • The cooking zone is still hot [ H ]. • The highest Booster level is set [ 9 ]. The control panel displays [ L ]: • Refer to the chapter control panel locking page. The control panel displays [ U]: • Refer to the chapter “Keep warm“. The control panel displays [ II ]: • Refer to the chapter “Stop&Go“.