This article explains how to assemble the BPOP-60 by Boretti.
INSTALLATION OF THE OVEN
To install the oven into the kitchen a cutout should be made in accordance with the dimensions shown in Fig. 1. The apparatus is to be fastened to the top by means of the two screws provided in the kit through the holes made on the oven uprights. The cabinet in which the apparatus is installed shall be open on the back side to ensure a sufficient air circulation and prevent overheating. Leave a gap of at least 200 cm2 (see Fig. 1) for air circulation if the oven is installed in a column; this is not necessary if the oven is installed under the work top.
WARNING
As the apparatus is to be fitted in your kitchen furniture, make sure that all surfaces in contact with the oven can resist a temperature of approx 90°C. Electricals Absorbed power: oven bottom element: oven top element: round element (hot air): roasting jack motor: lamp: hot air fan motor: cooling fan motor: 2400 W 2100 W 2300 W (on some models) 4 W (on some models) 25 W 25 W 25 W Maximum absorbed power: (see data plate). Supply voltage: (see data plate). NOTE This appliance is in compliance with following European directives: 2006/95/CE (LVD), 2004/108/CE (EMC), 2002/95/CE (RoHS), 2002/96/CE (WEEE), 2002/40/CE.