This article explains how to use the BPWKN 60 BPWKN 82 BPWKN 88 by Boretti.
Usage of the wine cabinet
The controls
- Run Indicator light illuminates to signify the cooling mode is currently in operation.
- Light To turn the inner light on/off. If you would like to change the light control mode, please follow the instructions below.
- Factory defaults setting is LF mode: The interior light will be on when you open the door, and the light will be off when you close the door.
- The LED light can be remained on continuously by pressing and holding the “LIGHT” button for 5 seconds, there is one BP sound and the display will show “LP” for 4 times before the display will revert back to normal. Then the light will remain on despite if the door is open or closed.
- If you press the light button for 5 seconds, there is one BP sound. It displays “LF”, four times of display blinking, then it will revert back to LF mode automatically. Caution When the door is open, you can manually press the “LIGHT” button to turn on or off the light, and when the door is closed, the light settings wont change from your last operation before the door closed. But when you open the door again, the light will remain on automatically.
- "Power" To turn this appliance on/off.
- "Set Upper" To set the temperature of the upper chamber.
- "Set Lower" To set the temperature of the lower chamber.
- "Upper chamber" To shows the temperature of the up chamber.
- "Lower chamber" To shows the temperature of the lower chamber. Upper compartment: The temperature setting can be adjusted from 5°C to 10°C. Lower compartment: The temperature setting can be adjusted from 10°C to 18°C. Note If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the wine cabinet will not start. When you use the wine cabinet for the first time or restart the wine cabinet after having been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the wine cabinet is running for a few hours the temperature will be back to normal. Temperature memory function If the power is suddenly lost, the set temperature will be saved by the unit. Once the power is back on the unit will be at the same set temperature. "Close door” reminder function When you forget to close the door or the door is not fully closed, there will be warning alarm after 5 minutes. How to remove the shelf
- Open the door completely.
- Remove all of the contents loaded on the shelf, if applicable.
- Pull the shelf towards yourself until it is fully extended outward.
- The shelf has plastic posts on both sides as indicated in the diagram below. While facing the unit, press the plastic post on the right side down while pulling up on the left plastic post. You may choose to do this by hand or by using a flathead screwdriver.
- Evenly pull out the shelf from the track until it is completely removed from the inner compartment.