This article explains how to use the BSI 83 by Boretti.
INSTRUCTION ON MOUTNING AND USE
Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Use The cooker hood is provided with an upper air exit B for discharging fumes externally for models including chimney flue C (Suction Version A- exhaust pipe not t supplied). If cooking fumes and vapours cannot be externally discharged, the cooker hood can be used in the recirculating version F: the installation of 1 active charcoal filter F allows the recirculation of fumes and vapours through the upper grid G. Electrical connection The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from he contacts. Operation R5 A:Lights ON/OFF Button: the extractor hood lights are turned on and off by pressing the button. B:Engine ON/OFF Button (4 speeds): the extractor is switched on by pressing the button. The extractor speed (power) can be adjusted using buttons "C" and "D". C:Extractor Speed (power) Reduction Button: the extractor speed is reduced by pressing the button. D:Extractor Speed (power) Increase Button: the extractor speed is increased by pressing the button. F:Timer Button: the 5-minute timer is activated by pressing the button, whatever the speed selected; the timer is deactivated by pressing the same button again. E:LED indicates the different speeds: green, speed 1; amber, speed 2; red, speed 3; blinking red, speed 4 (speed timer activated; it stays on for 7 minutes, then it automatically goes back to the last selected speed.) Do not use solvents to clean the control.