This article explains how to assemble the Majestic Professional - Quadra by Boretti.
INSTRUCTIONS FOR INSTALLATION
The instructions below are intended for the skilled technician who will install the cooker, regulate it and perform technical maintenance and who will ensure that these operations are carried out in the most correct way possible, in compliance with the regulations in force. Important: the cooker must be disconnected from the electric socket before performing all regulating or maintenance operations. RULES FOR INSTALLATION Installation must be carried out in a workmanlike manner, fully complying with the legislation in force. For GB IEE Regulation and by the laws of the local Water Undertaking. For IE Electrical regulations for installation and ventilation (ICP3, IS327, etc.). The installation must be conducted by a skilful technician according to the local and european standards in force. Installation of the cooker The cooker is protected against excessive overheating, so it may be installed next to furniture with a height no higher than that of the worktop. The wall in contact with the rear of the cooker must be made of fire-resistant material. To install the cooker correctly, take the following precautions. A. Any furniture in teh vicinity of the cooker with a height higher than that of the worktop must be at least 50 mm from the edge of the top. B. The extractor hood must be installed in the way indicated in its instructions booklet, and always at a minimum distance of 650 mm. C. If the cooker is installed under a wall unit, the minim distance between this unit and the worktop must be 700 mm (millimetres). Do not drag the cooker as this will bend the supporting feet. Lift the appliance when positioning it. ELECTRICAL CONNECTION The instructions below are intended for the skilled technician who will install the cooker, regulate it and perform technical maintenance and who will ensure that these operations are carried out in the most correct way possible, in compliance with the regulations in force. Important: the cooker must be disconnected from the electric socket before performing all regulating or maintenance operations. RULES FOR INSTALLATION Installation must be carried out in a workmanlike manner, fully complying with the legislation in force. For GB IEE Regulation and by the laws of the local Water Undertaking. For IE Electrical regulations for installation and ventilation (ICP3, IS327, etc.). The installation must be conducted by a skilful technician according to the local and european standards in force. Before connecting the appliance to the electric network, follow the instructions below: The fuse and electric feeding installation of your home must support the load of the appliance (see registration plate). The power supply system must have an efficient earth plate. The outlet or multiple-switch, with a minimum 3 mm contact opening, has to be easily reached once the appliance has been installed. The appliance is supplied without outlet: you need a normal one proper for the electric load. The power supply cable should not reach a 50°C temperature above the one of the surrounding. Important: make sure that the earth connection (yellow/green wire) is correct. The earth installation is compulsory. Generally our appliances are supplied with a 240 VAC single phase current. The installation of the kitchen must be performed by qualified personnel and carried out according to the standards in force. The scheme for the electrical connection is located on the label near the terminal. The Manufacturer declines any liability in case the standards are not observed. The cooker wiring diagram is given at the end of these instructions.