This article contains the manual for the BV-103 by Boretti.
Positioning and installing the appliance
indicated on the rating plate.
2. If the door opening direction is as required, go to Point 3. Otherwise, reverse the position of the hinges. To do this, carefully place the on its back, user spacers to prevent crushing the condenser pipes and damaging the compressor unit. When installing the appliance, remember the following: A Do not install it near to sources of heat such as heaters, radiators, cookers, etc. or in direct sunlight. B Make sure that during the automatic defrost, any water on the back wall of the compartment runs into the drain channel. C After the appliance has been placed in its final position, leave it for about at least an hour before connecting it to the power supply. D Make sure that the appliance is working properly before placing any food in it.
WARNING: DO NOT INSTALL THE APPLIANCE NEAR TO ANY HEAT SOURCES AND
LEAVE A GAP OF AT LEAST 5 CM ABOVE IT. INSTALLATION IN THE TALL UNIT HOUSING The dimensions of the tall unit housing must be correspond to those reported in the figure.