This article explains how to assemble the BV82 by Boretti.
Installation
Positioning
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For building-in and door reversibility refer to the relevant instructions. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. Important The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed. connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed.
Attention!
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. This appliance complies with the following E.E.C. Directives: CE 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications. 87/308 EEC of 2/6/87 relative to radio interference suppression. 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. Grid preparation Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). DO002/2 Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). To position the grid on the appliance proceed as follows: Apply the grid to the base of the appliance by pushing on to the clasps (a) until they click. DO001 Building in the appliance under a worktop Dimensions of the recess The dimensions of the recessed installation area must correspond with those indicated in the figure. 600 Installation kit 1xA 1xB 2xC DO013 550 min. 600 1 2xG 2xF 2xL 00 2xD 1xK 18xl