This article covers the warranty and environmental information for the BIKP-91 by Boretti.
Connexion électrique • L'installation de cet appareil et son branchement au réseau électrique ne doit être entrus- ted only to an electrician perfectly to the fact of the normative regulations and which respects them scrupulously. • Protection against the parts under tension must be ensured after the building-in. • The data of connection necessary are on the stickers place on the hob casing near the con- nection box. • The connection to the main must be made using an earthed plug or via an omnipolar circuit breaking device with a contact opening of at least 3 mm. • The electrical circuit must be separated from the network by adapted devices, for example: circuit breakers, fuses or contactors. • If the appliance is not fitted with an accessible plug, disconnecting means must be incorporated in the fixed installation, in accordance with the installation regulations. • The inlet hose must be positioned so that it does not touch any of the hot parts of the hob or oven. Caution! This appliance has only to be connected to a network 230 V~ 50/60 Hz. Connect always the earth wire. Respect the connection diagram. The connection box is located underneath at the back of the hob casing. To open the cover use a medium screwdriver. Place it in the slits and open the cover. Mains Connection Cable diameter Cable Protection calibre 230V~50/60 Hz (BE) 1 Phase + N 3 x 4 mm² 400V~50/60Hz (BE) 2 Phases + N 4 x 2.5 mm² H 05 VV - F H 05 RR - F H 05 VV - F 40 A 25 A 400V~50/60Hz (NL) 3 Phases + N 5 x 2.5 mm² H 05 RR - F H 05 VV - F 3 x 16 A* H 05 RR - F
- calculated with the simultaneous factor following the standard EN 60 335-2-6 Connection of the hob For the various kinds of connection, use the brass bridges which are in the box next the terminal. Monophase 230V~1P+N Put the 1st bridge between terminal 1 and 2 and between 2 and 3, the 2nd between 4 and 5. Attach the earth to the terminate “earth”, the neutral N to terminal 4 or 5, the Phase L to one of the terminals 1, 2 or 3. Biphase 400V~2P+N Put the 1st bridge between terminal 1 and 2, the 2nd between 4 and 5. Attach the earth to the terminate “earth”, the neutral N to terminal 4 or 5, the Phase L1 to the terminals 1 or 2 and the Phase L2 to the terminal 3. Triphase 400V~3P+N Put a bridge between terminal 4 and 5. Attach the earth to the terminate “earth”, the neutral N to terminal 4 or 5, the Phase L1 to the terminals 1, the Phase L2 to the terminal 2 and the Phase L3 to the terminal 3. Caution! Be careful that the cables are correctly engaged and tightened. We cannot be held responsible for any incident resulting from incorrect connection or which could arise from the use of an appliance which has not been earthed or has been equipped with a faulty earth connection. Environmental Regulations Should you wish to discard the machine for any reason, please comply with the following: Take the machine to the local authorized com- pany that collects discarded household appli- ances. Correct processing enable valuable ma- terials to be recycled in an intelligent manner. Before discarding your machine it is important that you cut off the power supply cord and re- move it together with the plug. This machine has been accorded the appropriate mark in ac- cordance with European Directive 2002/96EG regarding discarded electric and electronic equipment. This directive determines the standards for the collection and recycling of discarded equipment that apply to the entire territory of the European Union.