This article explains how to assemble the BIKP-91 by Boretti.
Instructions d'installation
Le montage relève de la compétence exclusive de spécialistes. L'utilisateur est tenu de res- pecter la législation et les normes en vigueur dans son pays de résidence. How to stick the gasket: La gasket supplied with the hob avoids all infil- tration of liquids in the cabinet. His installation has to be done carefully, in con- formity of the following drawing. Fitting - installing: • The cut out sizes are: Reference Cut-size 810 x 490 mm • Ensure that there is a distance of 50 mm between the hob and the wall or sides. • The hobs are classified as “Y” class for heat protection. Ideally the hob should be instal- led with plenty of space on either side. There may be a wall at the rear and tall units or a wall at one side. On the other side, however, no unit or divider must stand higher than the hob. • The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture, the laminate coatings and the glue used to fix them, must be able to resist temperatures of up to 100 °C. • The mural rods of edge must be heat-resi- sting. • Not to install the hob to the top of a not ven- tilated oven or a dishwasher. • To guarantee under the bottom of the hob casing a space of 20 mm to ensure a good air circulation of the electronic device. • If a drawer is placed under the work, avoid to put into this drawer flammable objects (for example: sprays) or not heat-resistant objects. • Materials which are often used to make worktops expand on contact with water. To protect the cut out edge, apply a coat of varnish or special sealant. Particular care must be given to applying the adhesive joint supplied with the hob to prevent any leakage into the supporting furniture. This gasket guaranties a correct seal when used in con- junction with smooth work top surfaces. • The safety gap between the hob and the coo- ker hood placed above must respect the indi- cations of the hood manufacturer. In case of absence of instructions respect a distance minimum of 760 mm. • Theconnectioncordshouldbesubjected,af- ter building, with no mechanical constraint, such for example of the fact of the drawer. • WARNING: Use only hob guards designed by the manufacturer of the cooking appliance or indicated by the manufacturer of the appliance in the instructions for use as suitable or hob guards incorporated in the appliance. The use of inappropriate guards can cause accidents.