This article explains how to assemble the FI-601 by Boretti.
Removing the oven door
The oven door can be removed quickly and easily. To do so, proceed as follows:
- Open the door fully;
- Lift the two levers shown in fig;
- Close the door as far as the first stop (caused by the raised levers);
- Lift the door upwards and outwards to remove it from its mountings. To replace fit the door, fit the hinges in their mountings and lower the two levers. Installation instructions Flush fitting The oven can be installed under a work top or in a cooking column. Figure shows the installation dimensions. Make sure that surrounding materials are heat resistant. Align the oven centrally with respect to the side walls of the units surrounding it and fix it in place with the screws and Allen screws provided. Insert the bushings provided in the holes in the face. Use the four screws provided to fasten the bushings to the cabinet, taking care not to over tighten and break the bushing. 595 560 50 min 500 540 00 0 594 595 560 50 min 500 00 535 594 See the accompanying instructions for combining the oven with multi-functional gas or gas-electric cookers. Electrical connections Before connecting the oven to the mains power supply, make sure that:
- The supply voltage corresponds to the specifications on the data plate on the front of the oven;
- The mains supply has an efficient earth (ground) connection complying with all applicable laws and regulations. Correct earthing (grounding) is a legal requirement. The power cable should never reach a temperature 50° C above ambient temperature at any point along its length. If a fixed appliance is not provided with a power cable and plug, or some other device permitting it to be disconnected from the mains electricity supply, with a gap between the contacts big enough to guarantee class III overvoltage protection, then such a device must be fitted to the power supply in compliance with the regulations governing electrical installations. The omnipolar plug or switch must be easy to reach when the appliance is installed. The unit becomes very hot during use. Be careful not to touch the heating elements inside the oven. If the oven came with a meat probe, use only the probe recommended for this oven. 0 000 3 1000 Cable types and minimal diameters SASO H05RR-F 3x1,5mm² H05RR-F 3x2,5mm² H05VV-F 3x1,5mm² H05VV-F 3x2,5mm² H05RN-F 3x1,5mm² H05RN-F 3x2,5mm² H05V2V2-F 3x1,5mm² H05V2V2-F 3x2,5mm² Gas or electrical connections 230V 1 2 3 4 5 。 R PE IL 230V
*3x4mm² 230V 3 1 2 3 4 5 230V3
*4x2,5mm² PE L2 L3 400V 2N 1 2 3 4 5 400V 2N~
*4x2,5mm² RS PE IL1 L2 400V 3N 1 2 PE L1 L2 L3 5 400V 3N~
*5x1,5mm² P400V3N~ N.B. The manufacturer declines all responsibility for damage or injury if the above instructions and normal safety precautions are not respected.