This article explains how to use the BGR-88 BGR-116 by Boretti.
Important: The appliance must be installed, regulated, connected to the gas network and electric mains, as well as adapted to the type of gas it will be fed with by qualified personnel, according to the norms in force and following the instructions in the second part of the in- struction booklet. Metal utensils should not be left on top of coo- ker as they are prone to heat up and cause burns. To find the knob that corresponds to the burner to use, refer to the silk screen printing on the control panel. Next to each knob there is a symbol that shows which burner it refers to. Each gas burner knob has the following symbols: Stop Maximum setting Minimum setting alight, keep the knob pressed right down longer to give the safety valve time to warm up. Check that the flame is regular and turn the knob to the setting required. If ignition is difficult or the flame irregular, check the correct position of the burner and its cover (Fig.1 ). The burner should be turned on before putting the pan on the rung. To turn a burner on, press the knob right down turning it counter-clockwise to the maximum position. When the burner is lit, let go of the knob after 5 seconds. If the burner fails to stay Fig.1 Burner cover Burner Nozzle holder Interchangeable nozzle To turn the flame off, turn the knob clockwise to the symbol. Before taking the pans off the rung, lower the flame or turn it off. If, when you're using the hob, the flame goes out acci- dentally the safety valve will stop the flow of gas in about 40 seconds. For a better use of the burners you should use pans with diameters that match the size of the burners so as to have maximum efficiency using as little gas as possible. It is also essential when you are cooking to cen- tre the pans on the burners and to use their lids. Burner Small auxiliary Medium semi fast Big fast Triple ring Dual Ø Pan in cm. Instructions for the installer Installation must be performed by a qualified installer and conform to local codes, and car- ried out with extreme care. Prior to installation, ensure that the local dis- tribution conditions (nature of gas and gas pressure) and the adjustments of the appliance are compatible. The gas adjustment conditions for this appli- ance are stated on the data plate located on the back of the appliance (see fig. 2) from Ø6 to Ø 18 from Ø15 to Ø22 from 20 to Ø28 from 24 to Ø32 from 24 to Ø32 As soon as the liquid in the pan starts to boil we advise turning the flame down just enough to keep the liquid boiling. It is important to remember that all the wor- king positions must be selected between the maximum and minimum position, never bet- ween the maximum and stop position. DO NOT USE the burners without the pan sup- ports supplied. Simmering aids such as asbes- tos or mesh mats are not recommended. They may impede burner performance, and damage the pan supports.
⚠ Attention: This appliance must only be used for home cooking. When the appliance is working it can get very hot so keep children away. fig. 2 CE Installation and adjustment must be done with maximum attention by qualified personnel and in accordance with current standards. If the appliance has to be adapted to a gas type different from the original one, enclosed with the guarantee you will find two labels for the installer to affix on the appliance's rating plate and on the guarantee to make the new adjust- ment known.