This article explains how to assemble the BIK-65 BIK-78 by Boretti.
Installation instructions
The installation comes under the exclusive res- ponsibility of specialists. The installer is held to respect the local legisla- tion and standards. How to fix the gasket: The gasket supplied with the hob avoids all infil- tration of liquids in the cabinet. This installation has to be done carefully, in conformity of the following drawing. 2 mm 2 3 Stick the gasket (2) two millimetres from the external edge of the glass, after removing the protection sheet (3). Fitting - installing: • The cut out sizes are: Reference Worktop cut-out (mm) Width x Depth BIK-65 560 x 490 BIK-78 750 x 490 • Ensure that there is a distance of 50 mm between the hob and the wall or sides. • The hobs are classified as “Y” class for heat protection. Ideally the hob should be instal- led with plenty of space on either side. There may be a wall at the rear and tall units or a wall at one side. On the other side, however, no unit or divider must stand higher than the hob. • The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture, laminate coatings and the glue used to fix them, must be able to resist tem- peratures of up to 100 °C. • The mural rods or edge must be heat-resi- sting. • Do not install the hob above a non ventilated oven or dishwasher. • Ensure a space under the bottom of the hob casing of 20 mm to ensure a good air circu- lation of the electronic device. • If a drawer is placed under the hob, avoid placing flammable objects in this drawer (for example: sprays) or non heat-resistant objects. • To protect the cut out edge, apply a coat of varnish or special sealant. Particular care must be given to applying the adhesive joint supplied with the hob to prevent any leakage into the supporting furniture. This gasket guarantees a correct seal when used in con- junction with smooth work top surfaces. • The safety gap between the hob and the coo- ker hood placed above must respect the indi- cations of the hood manufacturer. In case of absence of instructions respect a distance minimum of 760 mm. • The connection cord should be free of (me- chanical) constraints after installation, at all times.