This article covers maintenance and cleaning of the BIK-65 BIK-78 by Boretti.
Maintenance and cleaning
Switch-off the appliance before cleaning. Do not clean the hob if the glass is too hot due to risk of burn. • Remove light marks with a damp cloth with washing up liquid diluted in a little water. Then rinse with cold water and dry the surface thoroughly. • Highly corrosive or abrasive detergents and cleaning equipment likely to cause scratches must absolutely be avoided at all times. • Do not ever use any steam-driven or pres- sured appliance. Do not use any object that may scratch the ceramic glass. Ensure that the pan is dry and clean. Ensure that there are no grains of dust on your ce- ramic hob or on the pan. Sliding rough pans across the glass will scratch the surface. • Spillages of sugar, jam, jelly, etc. must be removed immediately to prevent the surface being damaged. What to do in case of a problem When the symbol ( E 4 1 appears : • The table must be reconfigured. Please implement the following steps : I) Important : before you start, make sure there is nothing on the hob II) Disconnect the appliance from the power supply by removing the plug, fuse or turning the circuit breaker off III) Reconnect the table to the grid IV) Procedure : take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
- start the procedure within 2 minutes after reconnecting the hob to the grid
- don't use the [0/1] touch